wire harness

Car Audio Wire Harness, Used to Connect Car Audio System.

汽车音频线束, 用于汽车音频系统.

Flight test vehicles require a certain degree of wiring and installation modification to accommodate flight test equipment. TSK produces test systems and adaptation units for wire harness inspection.

飞行试验机需要一定程度的配线和安装改动来适应飞行测试设备。我司为汽车行业提供检测成型线？的测试和适配系统。

Lay the engine wire harness into the plenum panel.

将发动机线束放至充压板上。

TSK produces test systems and adaptation units for wire harness inspection.

我司为汽车行业提供检测成型线?的测试和适配系统.

Lift engine wire harness up and out.

向上提出发动机线束。

Disconnect the power mirror wire harness retainers from the inner door panel.

从内侧车门饰板断开电动视镜电线束扣件.

Automotive Wire Harness and Cable Sets for Security Systems.

安全保险系统的线束.

Lower the overhead console far enough to access the two wire harness connectors.

降低正顶控制台,使得能接触到两个线束的接头.

Unplug the heater-A/ C housing wire harness connectors.

拔下加热器-A/C罩线束接头。

Unplug the brake lamp switch wire harness connector.

拔出刹车灯电线束接头.

Disengage the blower motor wire harness from the wire harness retainer.

把吹风机马达线束从连线线束夹扣中脱离出来.

Unplug the wire harness connector from the switch.

从开关拔出线束接头.

Apply to power cord, computer wire, wire harness and DC wire for tying.

适用于电源线、电脑线、线组及DC线等成品束线用。

Plug the in-vehicle temperature sensor wire harness connector into the instrument panel wire harness.

插车内温度感知器线束接头进仪表板线束接头.

Disconnect and isolate the battery negative cablUnplug the 2-way heated seat back wire harness connector.

断开并且绝缘电池负极电缆.拆下2路加热座椅垫线束接头.

Connect all lamp wire harness connectors.

连接所有灯电线束接头.

Connect the wire harness connector to the module.

连接线束至模组.

Unplug the wire harness connectors from the multi-function switch.

从多功能开关上拔出线束接头.

Wire Harness and Cable Assembly for Car Testing, Alarm, Security Systems Applications.

应用在汽车检测, 报警, 及保险系统的线束.

Disconnect retractor wire harness connector.

断开皮带卷收器线束接头.

Power seat wire harness slot

动力调节座椅线束槽

The wire harness circuits for the heater-A/ C control or the blend air door actuator. Easy design method for electric circuitry of sequential operating with several cylinders

空调暖气控制或混气门引动器线束电路。多气缸顺序动作电气控制回路的简便设计方法

Pull wire harness out through the seat frame.

穿过座椅骨架拉出线束。

Unplug the push button module wire harness connector from trip computer, compass, and thermometer display module.

从行车电脑, 罗盘, 和温度表显示模组上拆下按压按钮模组线束接头.

Remove wire harness for electrically adjustable seats.

拆下电动可调座椅的线束。

Move the BCM towards the steering column far enough to access the three wire harness connectors.

向着转向柱移动bcm足够远以便能碰到三个线束接头.

Unplug the power mirror wire harness connector.

拔去电动视镜线束接头.

I flip off the wire harness, ignite my jet pack,

我解开钢丝启动喷气背�

The switch wire harness must be disconnected before testing switch continuity.

在测试导通性之前必须断开开关线束.

Blue wire ( Signals) is not used. I cut the butt connectors off the relay harness and used those to tap into the parking lights.

蓝色电（信号）是没有用，我削减对接连接器小康继电器治理和利用这些进军停车灯。